Changing Printer Toner

Best Practices

• Mark toner boxes appropriately i.e. clearly label new ones "FULL".
• Handle the large cartridges carefully, holding them by the blue handles.
  • Failure to do so may cause carcinogenic toner to spill out, making a mess. If this happens, clean quickly with a damp piece of kitchen towel, or vacuum it up.
• Place used cartridges in an empty bin bag and tie it, with one cartridge per bag.

Office Printer

1. Switch off the printer.
2. Open the flap at the top.
3. Remove the old cartridge at a ~45 degree angle (a reasonable amount of force and wiggling is required).
4. Insert a new one in its place.
5. Close the hatch and send a document to check that it works.
6. In the printer options, select "LOW TONER - NO" (WIP).

Proj. Box Printer

1. DO NOT KNOCK THE PROJECTOR.
2. Move the posters in front of the printer away from the "Classically Forbidden Zone".
3. Switch off the printer.
4. Pull down the front of tray 1.
5. Lift up the top front panel of the printer.
6. Pull down the next front panel of the printer.
7. Holding the green tabs, pull down the final front panel of the printer, holding the green tabs at the sides. This should reveal the toner cartridges.
8. Pull the empty cartridge out straight.
9. Replace it in the same way, with the curved edges of the blue handles pointing down.
10. Close up the panels in reverse order and switch the printer back on.

Toner Storage Inventory

Toner is currently stored under the Proj. box floor, roughly underneath the farthest making-up bench. Below is a count of the toner currently stored there:

• Office Printer
  • 1 (Low on toner)

• Proj. Box Printer
  • 1 Cyan
  • 0 Magenta
  • 0 Yellow
  • 0 Key (Black)